• Deutsch
  • English

Cracked Fitting Holes

Step: 

Remove all loose particles. Clean surface.

Products required: 

Dye Rex-Lith Wood with Colour Touch-Up. Then mix with the appropriate quantity of hardener.

Products required: 

Put a plastic cap/lid into the fitting hole and apply the Rex-Lith compound to the damaged area (mould).

Products required: 

Before the Rex-Lith compound has fully cured, coarse projectings can be carefully cut off with a chisel.

Products required: 

Level the filled area with the Metal Planer.

Products required: 

Stretch a piece of Sandpaper ‚dry‘ tight around the Cork Sanding Block and remove final projectings while sanding also the surrounding area. Remove sanding dust afterwards.

Match filled damage to the colour of the surrounding area by misting with PF Acrylic Covering Lacquer from a distance of 30-40 cm – do not spray too wet. Repeat two or three times.

Products required: